Zone 1
RMS 550 |
RMS 550-Em |
 The RMS 550 range of zone 2 fluorescent luminaires is manufactured from AISI304 stainless steel. The body is fabricated from a single sheet of steel with no invasive mounting holes to minimize the risk of water ingress through the housing. The tempered glass window minimizes the risk of light output loss over time due to poly-carbonate yellowing. The RMS range is ideally suited for on and offshore and marine environments and all kinds of industry where there is a high level of corrosion. |
|
| Material | Stainless Steel AISI 304/AISI316 , 0.8 mm thickness and transparent part in tempered glass |
|---|---|
| IP Rating | IP66 |
| Temperature | -30°C to 55°C |
| Approvals | Atex-INERIS 01ATEX3002X & GOST |
| Standards | EN/IEC: 60079-0, 60079-15 & EN: 61241-0, 61241-1 |
| Ex-code |  II 3 GDEx nA II T5 Tamb. -30°C to 50°C Ex nA II T4 Tamb -30°C to 55°C Ex tD A22 T90° Tamb -30°C to 40°C Ex tD A22 IP66/67 T100° Tamb -30°C to 50°C Ex tD A22 IP66/67 T105° Tamb -30°C to 55°C According to European Directive 94/9/EC (ATEX)For Zone 2 and Zone 22 |
| Gaskets | Special cross section tightness gasket, silicon rubber made (close cells) located in housing channel between body and window frame. |
| Entries | Body complete of two diam. 21mm through holes for cable entries, one complete of metallic plug with lock nut and gasket, and the other one with plastic plug for dust protection. |
| Hardware and Screw | AISI 304 Stainless Steel external hardware and screws |
| Lamps | RMS Series is suitable for two pins fuorescent lamps G13 socket PHILIPS TL-D or equivalent.(lamps excluded) - 18 / 36 W |
| Ballast | High-frequency electronic ballast conforming with EN 60079-15 and IEC 60079-15 |
| Power Supply | 220-240 Volts AC 50 ÷ 60 Hz Power factor> 0.95 |
| Accessories Available upon request |
Suspension mounting kit "G1" AISI 304 made Pole mounting kit "P12" 1 ½" size AISI 304 made Wall mounting kit "H1" AISI 304 made |
| Emergency Service | RMS 550 lighting fxtures for Emergency Service are available:RMS 550...PNL/LE-P |
| Note | Very low pollution at the end of operative life time of lighting fxtures. The inorganic materials used for RMS, like stainless steel and glass, allow a recycle of 95%, only electrical components and insulation of single core wires need some more care. No through holes between inside and outside of luminaries, out of holes for power supply cable whatever protected by a suitable waterproof cable gland (on request). Therefore, during the time, release would be possible where, for fxing devices, there are through holes and relevant gaskets. |
